Original mirror cannot be used. Must order S41157 mirrors.

Items needed: Razor Knife, Metric Allen Wrench Set, Dykes  and 2 Hand Grips(C20-007-00200).

1. Cut off the handgrip on the left side of the handle bar.

2. Loosen the hand brake and slide it off the handle bar.

3. Screw the cable adjuster out completely.

4. Pull back on the hand brake to remove the adjuster.

5. Squeeze the hand brake to expose the cable sleeve and remove the cable from the hand brake.

6. Route the cable to the right side of the handle bar and install the cable into the hand brake by reversing steps 3, 4 and 5.

7. Cut off the handgrip on the right side of the handle bar.

8. Cut off the zip tie holding the throttle and speed switch cables.

9. Loosen the locking bolt of the speed switch and slide the speed switch off the handle bar.

10. Remove the clamp holding the throttle to the handle bar.

11. Slide the hand brake and then the speed switch on to the handle bar.

12. Slide a new handgrip onto the right side of the handle bar.

13. Slide the speed switch and hand brake against the hand grip and tighten the locking bolts.

14. Verify the throttle cable is not being restricted by other cables.

15. Install the throttle against the light switch cluster on the left side of the handle bar.

16. Install a new hand grip to the left side of the handle bar.

17. Remove the zip tie holding the light switch cluster to the handle bar.

18. Install a new zip tie to hold both the throttle and light switch cluster cables to the handle bar.

19.  Install a new zip tie to hold the speed switch cable to the handle bar.